Happymodel Bassline 2S 2inch Micro FPV Toothpick Drone - SPI Frsky D8/D16

Introducing the Happymodel Bassline 2s FPV Racer, designed in collaboration with team pilot Nathan Loopz and now available after being conceptualized in 2019. Experience ultimate control and performance with the X12 5-in-1 AIO flight controller featuring built-in 2.4G ELRS V2.0 and OPENVTX. Long-range transmission is made possible with the high-power 400mw VTX, and the drone can be upgraded to support ELRS V3.0 firmware. Powered by EX1103 KV11000 motors, the Bassline 2s delivers high speed and power. Capture stunning aerial footage with the CaddxFPV Ant FPV camera, and enjoy extended flight time with 2S batteries ranging from 350mah to 650mah (not included). The large battery tray accommodates batteries up to 17mm wide and 13mm in height. Features: X12 5-in-1 AIO flight controller with built-in 2.4G ELRS V2.0 and OPENVTX for ultimate control and performance High-power 400mw VTX for long-range transmission Upgradeable to support ELRS V3.0 firmware Equipped with powerful EX1103 KV11000 motors for high speed and power Features a CaddxFPV Ant FPV camera for stunning aerial footage Compatible with 2S batteries in the range of 350mah/450mah/550mah/650mah (batteries not included) Large battery tray can accommodate batteries up to 17mm wide and 13mm height for extended flight time. Battery for happymodel Bassline 2s toothpick:GNB 450mAh 2S Battery 7.6V 80/160C XT30 PlugSpecifications:Brand Name: HappymodelItem Name: Bassline 2S 2inch Micro FPV toothpick droneWheelbase: 90mmSize: 115mm*115mm*40mmAnalog version Weight: 40gram Analog version option:2.4G ELRS SPI SPI Frsky D8/D16SPI FlyskyPNP (without onboard receiver) Spare parts specifications:MotorMode: EX1103 KV11000Configu-ration:9N12PStator Diamter:11mmStator Length:3mmShaft Diameter:Φ1.5mmMotor Dimension(Dia.*Len):Φ13.5mm*15.5mmWeight(g):3.8gNo.of Cells(Lipo):1-2SPropellersWeight:0.88gMaterial: PCPitch:2.3inchProps Dia:52.17mmCenter Thickness:5mmCenter Hole Dia:1.5mmFlight controllerX12 ELRS V2.1 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280X12 Frsky V2.1 flight controller built-in SPI Frsky 2.4G receiver Target: CRAZYBEEF4FRX12 Flysky V1.0 flight controller built-in SPI Flysky 2.4G receiver Target: CRAZYBEEF4FSX12 PNP V1.1 flight controller without onboard receiver Target: CRAZYBEEF4DXMCU:STM32F411CEU6 (100MHZ, 512K FLASH)Sensor: ICM20689 or ICM42688P(SPI connection)Mount hole size: 25.5mm*25.5mmPower supply: 1-2S battery input (DC 2.9V-8.7V)Built-in 12A(each) Blheli_S 4in1 ESCBuilt-in Betaflight OSD(SPI Control)Built-in 5.8G OpenVTX 0mw~400mwBuilt-in ExpressLRS 2.4G,Frsky D8/D16,Flysky AFHDS 2ABuilt-in voltage detectionBuilt-in current sensor Onboard 4in1 ESCPower supply: 1-2S LiPo/LiPo HV Current: 12A continuous peak 15A (3 seconds)Support BLHeliSuite programmableDefault Factory firmware: Z_H_30_REV16_7.HEXDefault protocol: DSHOT300Support Bluejay firmwareOnboard SPI ExpressLRS 2.4GHz ReceiverPacket Rate option: 50Hz/150Hz/250Hz/500HzExpressLRS Firmware version: V2.0RF Frequency: 2.4GHzAntenna : SMD antennaTelemetry output Power: <12dBmReceiver protocol: SPI ExpressLRSCompatible with ExpressLRS V2.0 TX ModuleCouldn’t flash separately ExpressLRS firmware Could flash FC firmware to support ExpressLRS v3.0 TX moduleOnboard SPI Frsky D8/D16 receiver VersioSPI BUS receiver Frsky D8/D16 compatibleCompatible Non EU transmitter D8/D16 modelChannels: 8ch/16chNo ground interference ( Transmitter and receiver 1 m from the ground): 200meterFailsafe support Onboard SPI Flysky receiver VersionSPI BUS receiverProtocol: AFHDS-2A Channels: 14ch(AFHDS-2A)No ground interference ( Transmitter and receiver 1 m from the ground): 200meterFailsafe supportPNP Version(without onboard receiver)Full UART1 for external ReceiverSupport CRSF/GHOST/SBUS/IBUS/DSMX protocolIR1 pad(invert RX1) used for SBUS inputOnboard 5.8g OPENVTXFirmware version: OPENVTXSmartaudio v2.1PIT Mode supportRCE Mode supportChannels:48chTransmitting Power: 0/RCE/25mw/100mw/400mwPower supply: DC 5V Current (5v): <650ma (400mw)Caddx ANT 1200tvl cameraImage Sensor: 1/3" CMOS SensorHorizontal Resolution: 1200 TVLTV System: NTSC or PAL IMAGE: 16:9 or 4:3Synchronization: InternalElectronic Shutter: PAL: 1/50~100,000; NTSC: 1/60~100,000S/N Ratio : >52dB (AGC OFF)Video Output: CVBSLens: 1.8mmMin. Illumination: [email protected] Gain Control: YESWDR: Global WDRDNR: 3D DNRDimensions: 14*14mm(with bracket to 19*19mm)Wide Power Input: DC 3.7-18VWeight: 2g (N.W.) Package Included:1x Bassline 2inch frame and canopyOption1: X12 ELRS V2.1 flight controller built-in SPI ELRS 2.4G receiverOption2: X12 Frsky V2.1 flight controller built-in SPI Frsky 2.4G receiverOption3: X12 Flysky V1.0 flight controller built-in SPI Flysky 2.4G receiverOption4: X12 PNP V1.1 flight controller without onboard receiver4x EX1103 KV11000 brushless motor1x Gemfan toothpick 2023 tri-blade propellers(4cw+4ccw)1x Caddx ANT 1200TVL Camera1x Onboard 5.8G Openvtx 0mw~400mw VTX1x Canopy for 14mmx14mm camera1x Screw driver